) 
Post by Steve King (Admin) on Jul 4, 2009 17:31:26 GMT -6
Sold at www.STLCornhole.com in the supplies section.
Chrome cornhole scorekeeper inserts easily fit firmly and flush into a hole cut exactly 1-3/4" tall x 5" wide. Do not cut the hole any larger than these dimensions, since the face of the chrome scorekeeper is 2" tall x 5-1/4" wide. The chrome part is metal, not plastic. These really classy up your Cornhole boards. This chrome scorekeeper insert is for Cornhole boards with 1x4 or 2x4 sides. The chrome scorekeeper is 1-1/2" deep and a 2x4 board is 1-1/2" thick and a 1x4 board is 3/4" thick (as shown installed below in a 1x4 board). You will need to cut the hole with either a jig saw or a route it out. You can start a pilot hole in the wood by drilling a hole with a drill bit to fit your cutting bit in to cut or route out the hole. A 1x4 and 2x4 board are both 3-1/2" wide and this scorekeeper is 2" tall, so there is plenty of room for centering it on the board.
There are no screws needed. It just pops right into the cut hole and stays. The edges of the chrome scorekeeper have pointed & flexible metal tips that will grab the inside edge of your cut wood hole. So, once you push it into the hole there's no pulling it out or it falling out. It is in there firmly to stay. However, if you must remove it, then it can be done with a few small, thin screwdrivers. Just access it from the inside of the board and press on the edge clips to relieve the pointed edges from pushing into the edge of the wood.
CLICK TO ENLARGE
